| 7-1 Insulation Resistance (Unmated) | Between adjacent contacts and contacts and ground. | EIA 364-21C, Apply 100Volts DC | 100M minimum |
| 7-2 Low Level Contact Resistance | Initial for VBUS and GND contacts and all other contacts; delta. | EIA 364-23b, 100mA max., 20mV Max. open circuit | 40m(Max) initial, 10m(Max) after test |
| 7-3 Dielectric Withstanding Voltage | Between adjacent terminals. | EIA 364-20, Subjected to 100VAC (RMS) for 1 minute | There shall be no breakdown |
| 7-4 Contact current rating | When the currents are applied to the contacts, the temperature rise
shall not exceed 30 C. | EIA364-70, Ambient temperature 25 C | VBUS: 5.0A, VCONN: 1.25A, Other contacts: 0.25A |
| Cycle Test | Must meet the following criteria after the cycle test is completed. | EIA 364-09, Type C: 10000 cycles, rate of 200 cycles per hour
manually | Contact resistance (40m > delta 10m (Max) after test), Insertion
force (5N to 20N), Extraction force (8N to 20N), Visual inspection
(no exposed base metal on contacts) |
| Cable Flexing | No discontinuity over 1 microsecond during flexing or physical
damage allowed. | EIA 364-41, 100 cycles in each of 2 planes 120 degree. Dimension
x=3.7x cable diameter | No discontinuity over 1 microsecond |
| Cable Pull-Out | No discontinuity or physical damage allowed. | EIA-364-38, 40N steady state axial load for 1 minute | No discontinuity or physical damage |
| 4-axes continuity test | No discontinuity greater than 1s and no physical damage to the
specimen. | EIA-364-38, 8N tensile force for a period of 10 seconds; Subject to
0, 90, 180, 270 direction. | No discontinuity greater than 1s |
| Temperature Life | Visual inspection, Test shall be done in sequences defined in EIA
364-1000.01. | EIA 364-17, 105C without applied voltage for 120 hours. 105C
without applied voltage for 72 hours when used as preconditioning
in EIA 364-1000.01. | Shall meet visual requirement |
| Thermal Shock | There shall be no evidence of any physical damage. | EIA 364-32, 10 Cycles -55C and +85C. The USB 3.0 connectors under
test must be mated. | No physical damage |
| Salt Spray | 1).Shall meet visual requirement, show no physical damage. 2).Shall
meet requirements of additional tests as specified in test sequence
in Section 5. | MIL-STD-202F, Method 101D, Test Condition B, Subject mated
connectors to 48 hours at 35C with 5%-Salt-solution concentration. | Visual inspection, No physical damage |
