VMC-1890HL Machining Center Vertical Low Friction High Precision Large Size Worktable

• Full-series roller linear guideways for reduced motor burden
• High load capacity with low friction and high precision
• Large-size worktable for wide machining range
• Wide-field spindle motor for stronger cutting force

Mechanical manual tool magazine, rear-flush chip removal, spindle oil cooler, water gun, air gun, spindle air curtain, spindle ring spray, centralized lubrication, air source treatment, oil-water separation, heat exchanger, nitrogen balance

Mitsubishi/Syntec system, hollow screw, chain-type chip removal, grease lubrication, electrical cabinet air conditioner, 4-axis, 5-axis, column heightening, tool internal cooling, fixtures, clamps

※ The product appearance and configuration are subject to improvement with technological development, but will not be lower than current technical requirements. No separate notification will be given; the specific details shall be based on the technical agreement at the time of purchase.

Note①: The 3-axis power and torque are based on FANUC. For detailed information on Mitsubishi, Syntec and other systems, please consult the corresponding account manager.

Note②: In case of stock shortage, equivalent specifications (such as HIWIN, Rexroth, THK) will be used as substitutes. No separate notification will be given.

Note③: Optional 30-tool capacity for the tool magazine.

Note④: This dimension does not include the water tank (the width of the rear-flush water tank increases by 550mm) or the chain (the length of the chain increases by 1000mm). Select one option based on the actual configuration.