| Scope | 0.8 series connector strip including product performance, test
methods and inspection requirements. |
| Applicable Standards: GB/T2421, GB/T2423, GB/T2424, GB/T5095 |
| Appearance | Product surface without defect, dirt, crack, and mechanical damage;
Contact without rust plating, oxides and not peeled. |
| Dimension | According to drawings. Exchangeable with same specification
products. |
| Use Condition | Ambient temperature Range | -25 +85 |
| Applicable Wire Sizes | AWG #2832 |
| Applicable PC board thickness | 1.6mm |
| Material | Contact | Phosphor bronze, Tin plating: 24m, Thickness: 0.15mm | P/N: HC-0.8 - **** |
| Housing Plastic | LCP UL94V-O, Color: Nature | P/N: HC-0.8 - **** |
| Wafer | LCP UL94V-O, Tin plating: 24m, Color: Nature | P/N: HC-0.8 - **** |
| Electrical Performance | Rated Voltage | 30V AC/DC | |
| Rated Current | 0.5A AC/DC | |
| Contact Resistance | Initial value 20; After environmental test 40m | Apply 200V AC(rms) for 1 minute between adjacent contacts, leakage
current < 0.5mA; Mate connectors: Max 20mV, Max 100mA. |
| Insulation Resistance | 100 M | Apply 250V DC(rms) for 1 minute between adjacent contacts. |
| Mechanical Performance | Single contact insertion force | 3N | Mate connectors, insertion force test at 253mm/min. |
| Single contact withdrawal force | 0.1N | Terminal and hole seat pull-out force at 253mm/min. |
| Terminal crimping Wire strength | 2N (AWG#32), 3N (AWG#30), 4N (AWG#28) | Axial pullout force at 253mm/min. |
| Pin Retention Force | 8N | Housing with terminal, insertion force test at 253mm/min. |
| Fixed terminals And hole seat | 2N | Terminal and hole seat pull-out force at 253mm/min. |
| Durability | Contact Resistance 40m | 30 cycles (10 cycles/min) before environmental test. |
| Environmental Performance | Thermal Aging | Appearance: No damage, Contact Resistance 40m | 852, 96 hours continuously. |
| Temperature Rise | | Mate connector measures temperature rise at max rated current. |
| Constant Humidity | Appearance: No damage, Contact Resistance 40m, Insulation
Resistance 100m | 402, 90-95% RH, 96 hours continuously. |
| Temperature Cycling | Appearance: No damage, Contact Resistance 40m, Insulation
Resistance 100m | -553 (30min) to 853 (30min), 10-15min transition, 5 cycles. |
| Salt Spray | Appearance: No damage, Contact Resistance 40m | 353, 51% Salt solution, 8 hours. |
| Solder Ability | Solder ability | Area of soldering: 90% | Solder temperature: 2455C, Immersion period: 30.5S. |
| Resistance to soldering heat (Manual) | Appearance: No damage | Soldering temperature: 3505, Soldering time: 30.5S. SMT type needle
solder position, 0.5mm from conductor. |
| Resistance to soldering heat (Reflow) | Appearance: No damage | Soldering time: 20S Max. Soldering temperature: 255 5. Refer to 9.1
reflow temperature curve. |
| Packaging, Transportation, Storage | Store in a warehouse with ambient temperature of -20 +40, relative
humidity 80%, and no corrosive gases. Re-qualification test
required if stored for over 6 months. |
