| RATING |
| Rated Value | | DC5V 3A |
| PRACTICAL TEMPERATURE RANGE |
| Operating Temperature | | -30~80 |
| STANDARD ATMOSPHEIC CONDITIONS |
| Temperature | For measurements and tests | 5 to 35 |
| Humidity | For measurements and tests | 45% to 85% |
| Pressure | For measurements and tests | 86Kpa to 106Kpa |
| MECHANICAL |
| Connection Force | After 3 cycles of connecting and disconnecting using standard plug
gauge | 0.5-2.0Kgf |
| Disconnection Force | After 3 cycles of connecting and disconnecting using standard plug
gauge | 0.8~2.0Kgf |
| Terminal Strength | Static load of 0.1N/m (1kgf/cm) applied to terminal tip for 1 min
in any direction | No damage to terminal; electrical and mechanical characteristics
satisfied. |
| ELECTRICAL |
| Contact Resistance | Measured at small current (100mA) at 1000Hz | 50m MAX |
| Insulation Resistance | Apply 100V DC for 1 min between specified portions | 100M MIN |
| Dielectric Strength | AC 100V rms (50~60Hz) for 1 min, trip current: 0.5mA, between
specified portions | No damage, arcing, or breakdown |
| DURABILITY |
| Solderability Test | Terminal tops dipped 1mm in solder bath at 2505 for 50.5 seconds | Solder wetting time 3 sec; Soldering area > 75% |
| Resistance to Soldering Heat Test (Reflow) | Preheat: 180 for 120s; Peak temp: 2605 within 20s | No deformation of case or excessive looseness of terminals;
electrical characteristics satisfied. |
| Resistance to Soldering Heat Test (Soldering Iron) | Bit temperature 3305, application time 30.5 sec | No deformation of case or excessive looseness of terminals;
electrical characteristics satisfied. |
| Humidity Test | Stored at 402 and 90%-96% humidity for 96 hours, then 1 hour at
standard atmospheric conditions | Appearance no abnormal; mechanical and electrical characteristics
satisfied. |
| Heat Test | Stored at 702 for 96 hours, then 1 hour at room temperature | Appearance no abnormal; mechanical and electrical characteristics
satisfied. |
| Cold Test | Stored at -253 for 96 hours, then 1 hour at room temperature | Appearance no abnormal; mechanical and electrical characteristics
satisfied. |
| Life Test (Without Load) | 5000 cycles of connection/disconnection at 10-25 cycles/min | Contact Resistance 0.1; Disconnection Force 0.8-2.0N; Mechanical
and electrical characteristics satisfied. |
| Life Test (With Load) | 5000 cycles of connection/disconnection at 10-20 cycles/min under
rating condition (non-inductive load) | Contact Resistance 0.1; Disconnection Force 0.8-2.0N; Mechanical
and electrical characteristics satisfied. |
| Temperature Cycling Test | 5 cycles of specified temperature conditions, then 30 min at room
ambient | No deformation or cracks in molded part; Insertion & Extraction
Force: 3-20N; Contact Resistance: Max.30m; Insulation Resistance:
Min.100 M; Dielectric Withstanding Voltage: 100VAC/min (between
terminals). |
| Cold & Heat Shock Test | 5 cycles of specified temperature conditions, then 30 min at room
ambient | No deformation or cracks in molded part; Insertion & Extraction
Force: 3-25N; Contact Resistance: Max.30m; Insulation Resistance:
Min.100 M; Dielectric Withstanding Voltage: 500VAC/min (between
terminals). |
