| 4.1 Electrical Performance |
| Contact Resistance | 20 mMAX | Mate applicable FPC/FFC and measure by dry circuit, 20mV MAX, 10mA. |
| Insulation Resistance | 500MMIN | Mate applicable FPC/FFC and apply 500V DC between adjacent terminal
or ground. |
| Dielectric Strength | No Breakdown | Mate applicable FPC/FFC and apply 200V AC (virtual value) for
1minute between adjacent terminal or ground. |
| 4.2 Mechanical Performance |
| Locking Force | 1.96*n (N) MAX | Insert and extract applicable FFC at the speed rate of
253mm/minute. |
| Withdrawal Force | 0.49*n (N) MIN |
| Terminal /Housing Retention Force | 3.92N MIN | Pull the terminal at the speed rate of 25 3mm per minute |
| 4.3 Environmental Performance and Others |
| Repeated Insertion and Withdrawal | Contact Resistance 60 m MAX | Insertion and withdrawal actuator up to 20 cycles at the speed rate
of less than 10 cycles/minute |
| Temperature Rise | Temperature Rise 30 MAX | Carrying rated current load. (UL 498) |
| Vibration | Discontinuity 1 ms MAX. Appearance: No Damage | Amplitude: 1.5mm P-P Sweep time: 10-55-10Hz in 1 minute Duration: 2
hours in each X.Y.Z. axes. DC 1mA energized. |
| Shock | Discontinuity 1 ms MAX. Appearance: No Damage | 490m/s2{50G}, 3 strokes in each X.Y.Z. axes. DC 1mA energized. |
| Heat Resistance | Contact Resistance 60 m MAX. Appearance: No Damage | 852, 96 hour. Then return to room temperature for 1-2 hours. |
| Cold Resistance | Contact Resistance 60 m MAX. Appearance: No Damage | -402, 96 hour. Then return to room temperature for 1-2 hours. |
| Humidity | Insulation Resistance 20 M MIN. Appearance: No Damage | Temperature: 402 Relative Humidity: 90-95% Duration: 96 Hours. Then
measure within 0.5 hours at room temperature. |
| Temperature Cycling | Contact Resistance 60 m MAX. Appearance: No Damage | 5 cycles of: a) -452 30 minutes b) 852 30 minutes. With 10-15
minutes at room temp. |
| Salt Spray | Contact Resistance 60 m MAX. Appearance: No Damage, Corrosion | 484 hours exposure to a salt spray from the 51% solution at 352.
After test, wash with room temperature water and dry. |
| SO2 Gas | Contact Resistance 60 m MAX. Appearance: No Damage | 24 hours exposure to 505ppm SO2 gas at 402. |
| NH3 Gas | Contact Resistance 60 m MAX. Appearance: No Damage | 40 minutes exposure to NH3 gas evaporating from 28% Ammonia
solution. |
| Solder ability | Solder Wetting 95% | Soldering Time: 20.5 sec. Soldering Temperature: 2355 0.2 mm from
terminal tip. |
| Resistance to Soldering Heat | Appearance: No Damage, Deformation | Soldering Time: 50.5 sec. Soldering Temperature: 2605 0.2 mm from
terminal tip. |
