| Material Details | Plastic Part: LCP UL94V-0 | |
| Contact Terminal Part: C5191-EH, Nickel base, Gold plated contact
area 1 | |
| Shell Part: H65, Nickel plated base 50, Tin plated 80 | |
| Mechanical Performance | Insertion Force: 3.0kgf MAX | Reference: EIA 364-13A (Insertion force when mating with cable end
at 25mm/min speed) |
| Extraction Force: 0.7~1.8 kgf MIN | Reference: EIA 364-13A (Extraction force when mating with cable end
at 25mm/min speed) |
| Terminal Single PIN Holding Force: 0.5 kgf MIN | Reference: EIA 364-09A (Force for contact PIN to withdraw from
plastic at 25mm/min speed) |
| Durability Test: 3000 cycles | Reference: EIA 364-28A (Uniform insertion and extraction at 600
cycles per hour) |
| Electrical Performance | Contact Resistance: 50m MAX | Reference: EIA 364-23A (Test contact resistance of product contact
area with low power current) |
| Insulation Resistance: 100M MIN | 100V DC |
| Withstanding Voltage Test: 300V AC 1 minute 0.5mA | Reference: EIA 364-20A (Test plastic withstand voltage between
contact pins for 1 minute with 0.5mA current) |
| Plastic Impedance between adjacent contact pins: 100M MIN | Reference: EIA 364-21A (Test plastic impedance value between
adjacent contact pins with 0.5mA current) |
| Working Current: 1.0 Ampere | |
| Environmental Performance | Tin Adhesion: Tin adhesion area reaches over 95% | Product welding area immersed in tin furnace at 2355 for 50.5
seconds. Reference: MIL STD-202F |
| High Temperature Resistance: No obvious damage to appearance | Place product in 85 high-temperature oven for 96 hours, then place
at room temperature for 3 hours for observation. Reference: MIL
STD-1344A |
| Low Temperature Resistance: No obvious damage to appearance | Place product in -40 low-temperature oven for 96 hours, then place
at room temperature for 3 hours for observation. Reference: MIL
STD-1344A |
| Humidity Resistance: No obvious damage to appearance | Place product in an environment of 402 and 9095RH for 120 hours,
then observe. Reference: EIA 364-31A |
| Corrosion Resistance: No obvious corrosion | Place product in a salt spray chamber with 5% salt water
concentration at 352 for continuous spraying for 12 hours, then
place at room temperature for 1 hour for observation. Reference:
EIA 364-26A |
| Solderability: No obvious discoloration or blistering; smooth
solder joints | Recommended reflow curve: ... (Details not fully provided in
source) |
| Working Conditions | Operating Temperature: -30+80 | |
| Vibration Test | Continuous testing for 2 hours in X/Y/Z directions, frequency from
10HZ to 55HZ and back to 10HZ per minute, amplitude 1.5mm.
Reference: EIA 364-28A | |
