| Dielectric Strength | Between conductors (1 minute, 500V AC) | No damage, arcing, or breakdown. Trip current: 2mA. |
| Dielectric Strength | Between each terminal and insulated metal part (1 minute, 500V AC) | No damage, arcing, or breakdown. Trip current: 2mA. |
| Operating Force | Insertion and withdrawal force (after 3 cycles) | Insertion: 3N~30N (0.3kgf~3.0kgf). Withdrawal: 3N~30N
(0.3kgf~3.0kgf). |
| Soldering Test | Temperature: 245C 3C, Time: 2~3 seconds, Length: 2 mm, Solder:
Sn/3.0Ag/0.5Cu, Flux: 25%Resin/75%IPA | Soldered area covered minimum 95% of immersed surface. |
| Low Temperature Storage | Stored for 96 hours at -25C 3C | Dimensional, electrical, and mechanical characteristics satisfied. |
| Dry Heat Storage | Stored for 96 hours at 70C 2C | Dimensional, electrical, and mechanical characteristics satisfied. |
| Humidity Test | 40C 2C, 90%~95% RH for 96 hours, followed by 30 minutes in room
ambient | Dimensional, electrical, and mechanical characteristics satisfied. |
| Insulation Resistance | - | 50M MIN. |
| Operating Endurance | 5000 cycles (inserting and withdrawing) at 10-30 cycles/min | Dimensional, electrical, and mechanical characteristics satisfied. |
| Contact Resistance | - | 100m MAX. |
| Reflow Heat Resistance Test | Pre-heat: 150C ~180C (90~120s), Peak temp: 245C 5C (10s within),
Above 220C: 30~60s within | Electrical characteristics satisfied. No damage after reflow. |
| Composite Temperature/Humidity Cyclic Test | 4 cycles (conditions not fully detailed, but subject to ambient
return) | Electrical and mechanical characteristics satisfied. |
