| RATING | DC Voltage | | 30V |
| Current | | 1.5A |
| PRACTICAL TEMPERATURE RANGE | Usage Range | | -25 ~ 85 |
| Standard Atmospheric Conditions for Testing | Temperature: 5 to 35
Humidity: 45% to 85%
Pressure: 86Kpa to 106Kpa | |
| MECHANICAL | CONNECTION FORCE | After connecting and disconnecting using standard plug gauge 3
times. | 3.57Kgf MAX |
| DISCONNECTION FORCE | After connecting and disconnecting using standard plug gauge 3
times. | 1.02Kgf MIN |
| TERMINAL STRENGTH | Static Load | 0.1N/m(1kgf/cm) applied to the tip of the terminal for 1 min in any
direction. | No damage, satisfies electrical and mechanical characteristics. |
| ELECTRICAL | CONTACT RESISTANCE | Measured at small current (100mA or less), 1000Hz | 30m MAX |
| INSULATION RESISTANCE | Apply 100V DC for 1 min between various portions (body/conductor,
non-contacting conductors, conductors when plug is inserted). | 1000M MIN |
| DIELECTRIC STRENGTH | Apply AC 500V rms (50~60Hz) for 1 min, Trip Current: 0.5mA between
various portions. | No arcing or breakdown. |
| DURABILITY | SOLDERABILITY TEST | Terminals dipped 1mm in solder bath at 2305 for 50.5 seconds. | Solder wetting time 3 sec; Soldering area > 75%. |
| RESISTANCE TO SOLDERING HEAT TEST | Soldering iron method: Bit temperature 3305, application time 30.5
sec (no excessive pressure). | No deformation of case or excessive looseness of terminals;
satisfies electrical characteristics. |
| HUMIDITY TEST | Stored at 402 and 90% to 96% humidity for 96 Hr, then maintained at
standard atmospheric conditions for 1 Hr. | No appearance damage; satisfies mechanical and electrical
characteristics. |
| HEAT TEST | Stored at 702 for 96 Hours, then subjected to controlled recovery
for 1 Hour. | |
| COLD TEST | Stored at -253 for 96 Hours, then subjected to controlled recovery
conditions for 1 Hour. | No appearance damage; satisfies mechanical and electrical
characteristics. |
| LIFE TEST | Without Load | Connection and disconnection for 5000 cycles at 10 to 25
cycles/min. | |
| With Load (Rating Condition, Non-Inductive Load) | Connection and disconnection for 5000 cycles at 10 to 20
cycles/min. | Contact Resistance 0.1; Disconnection Force 0.8 to 2.0N; Satisfies
mechanical and electrical characteristics. |
| TEMPERATURE CYCLING TEST | Conditions | 5 cycles of specified temperature profile (e.g., -20 to 80). | No deformation or cracks in molded part. Insertion/Extraction
Force: 3 to 20N; Contact Resistance: Max. 30m; Insulation
Resistance: Min. 100 M; Dielectric Withstanding Voltage: 100VAC/min
(between terminals). |
| Recovery | 30 minutes in room ambient condition after cycling. | |
| COLD & HEAT SHOCK TEST | Conditions | 5 cycles of specified temperature shock profile (e.g., -20 to 70). | No deformation or cracks in molded part. Insertion/Extraction
Force: 3 to 25N; Contact Resistance: Max. 30m; Insulation
Resistance: Min. 100 M; Dielectric Withstanding Voltage: 500VAC/min
(between terminals). |
| Recovery | 30 minutes in room ambient condition after cycling. | |
