Optical Fiber Curing Oven Fiber Optic Tools Power 750W Heating
This equipment employs two sets of independent precise heating
control systems to respectively control two heating boards which
are able to simultaneously cure 24 ferrules (standard dimension is
φ 2.5mm). This equipment features high production efficiency,
stable and reliable quality. (Note: D employs one set of precise
heating control system and one heating board.) Different types of
products can be cured using different heating tools.
Name and function of each part
1. Heating tool
It is a dismountable fixture, which is used to install the ferrule
to be cured, and
is inserted into heating board to heat ferrule to be cured.
2. Heating board
It is securely mounted on panel, and internal heating device is
used to generate heating and cure ferrule.
Type of fuse is 2A/220V
It is used to control heating temperature of heating board, and
temperature can be adjusted within 60℃~150℃ (it is prohibited to
make temperature over 150℃, otherwise the equipment will be
It is used to turn on or off the power.
Press this switch to start up time relay, and press twice
continuously this switch to stop timer.
Adjusting parameters of time relay can shorten or prolong heating
and curing time (now relay is working).
8． Heating-on indicator
When this indicator is on, the equipment is in heating status.
When this indicator is on, the equipment stops heating
Chapter 3 Operation
3.1 Check before startup
1．Check whether component of equipment is complete
2．Check whether screws and buttons on panel are loose or missing
3．Check whether power line is properly connected
3.2 Setting of heating temperature and time
3.2.1 Setting of heating time
1. Remove the enclosure of temperature controller and time relay on
2. Adjust digital parameters to set required temperature and time.
3. Install the enclosure.
3.2.2 Setting of heating temperature
1. Press MODE button, the red number on panel representing
changes into as shown in left, and now change the green number
number to set temperature.
Chapter 4 Common failures and causes
The following are some failures occurring to curing oven and
remedies. Please duly
contact us for the failures which occur in your equipment and are
not shown in the
Common failures and causes:
Power indicator is not on
Power plug is not properly
Properly connect the
|Fuse damaged||Replace fuse|
Press timing-on button,
timer is not on
|Timer is set to zero||Reset timer|
|Timer does not work|
Replace with a new
|Ferrule can not be cured||Set temperature is too low|
|Set time is too short||Prolong curing time|
Heating board can not
|Temperature is set to zero|
Chapter 5 Annex
5.1 Main parameters of equipment
Voltage 220V±10% 50Hz
Power 750W(D 400W)
Overall dimension 550mm(L)×180mm(H)×350mm(W)
Ambient temperature 10℃~40℃
Relative humidity 15~85%
5.2 Optional parts of equipment
Heating tools: φ3.0,φ2.0,φ0.9 ,ST and φ1.25/ 2.0 type; Custom
heating tool is
also optional on client’s request.